This SmartGate Feature can Deny Access to Users, based on Worker In - Questions Answered: 


  • First set the Team Safety Credentials, we support a number of fields that can be configured but correct answer will ONLY be validated against the 3 fields mentioned below:
  • Team Safety Credentials → Question Type.
  • Rest of the field types will not be changed, will have either the Default/Correct answer.




  • Question Type contains 3 options:
  •     Yes/No
  •     Single Choice
  •     Multiple Choice


  • The new 'Default Answer and Correct Answer' will show up for all the three Question types Yes/No, Single Choice, Multi Choice When marked as Default Answer, In all the places this field is shown, the default answer will be loaded on the form
  • When marked as Correct Answer, During Smart Gate Access validate what the Correct Answer has been set up vs what was answered by the User during SmartGate access. If the answers are right then the access  is allowed else deny access (This use cases has been covered in sections below)

Note: Rest of the MD field types in Team Safety Credentials will NOT be changed to have either the Default/Correct answer.  

  • Below is an example of Question Type → Single Choice 
  • For Single Choice, Both Default Answer & Correct Answer will be a single choice selection. 
  • Available Choices (<Text has been updated as shown in the image below>)


  • Below is an example of Question Type → Multi Choice 
  • For Multiple Choice, Default Answer will be a single choice selection, however Correct Answer will be a multi choice checkbox as more than one correct answer can be selected. 
  • Available Choices (<Text has been updated as shown in the image below>)

  • Below is an example of Question Type → Yes/No. For Yes/No, Only Correct Answer can be picked, Using the 'Select the radio button to mark the correct answer'


SmartGate to deny access based on the Question answered

  • Worker at the SmartGate will scan the badge and the next set of UI will appear 


  • Once a worker scans the badge that is NFC enabled, it will send a notification query to the project team and it will see if the user is Valid. If the user is valid, it is going to check if the 'Worker In' Questions are configured. If the questions are configured for Worker IN, it will ask you the following question: ' To complete your Time In you need to answer one or more questions.



  • Worker clicks 'OK' to proceed. Worker In questions configured will show up, and User clicks 'Next' to proceed.


  • With all the questions Answered, Worker clicks the 'Done' button.


  • When Worker clicks on 'DONE', with all the questions answered, VALIDATE ALL the questions answered by the Worker against the 'Worker In' questions in 'Team Safety Credentials' marked as 'Correct Answer'. ONLY when ALL the questions have the correct answer, then the Worker is Timed In successfully.


  • When Worker clicks on 'DONE', with all the questions answered, If at least one of the question answered in INCORRECT that does not match with the correct answer configured, then SmartGate does not Time in the worker rather shows that 'ACCESS DENIED' and after a few seconds SmartGate will show the Home screen where the worker will need to scan the badge again and answer the questions to get access in.


  • Access Denied screen is shown for a few seconds and the user is navigated back to Smart Gate Home screen, 
  •  Red X indicates a failed validation state
  •  Green tick would indicate a successful validation
  •  Grey tick indicates that the validation has not happened.


As a continuation to understand the above, 'SmartGate - Live Attendant & SmartGate Settings from Project Menu' could be helpful topics.






Last Updated: Dec-15-24